Can't flashing in the car ! (Bench flashing is fine)

Pages: [1]

« previous next »

Author

Topic: Can't flashing in the car ! (Bench flashing is fine) (Read 3329 times)

AndrewS

Newbie

Karma: +0/-1
Offline

Offline

Posts: 11

	Can't flashing in the car ! (Bench flashing is fine) « on: March 12, 2015, 08:37:42 PM »

Hi

I'm remaping my TT 180.

I installed bigger turbine(td05-14g), intercooler and custom induction/downpipe.
I can correct checksum and bench flashing.!so I started MLHFM correction to adjust MAF scale for induction kit.
(I'm using stock MAF housing but I installed custom induction kit/fillter.)
I increased MLHFM 15% but my WBO2 show to lean.(15~16)

I think I should try this manytimes but Reinstall ECU is too hard.
I'm using Galletto for flashing but I couldn't go bootmode in the car.

anybody can flashing in the car?
Please tell me how to flashing in the car.


	Logged

jogtx16v

Full Member

Karma: +6/-1
Offline

Offline

Posts: 139

	Re: Can't flashing in the car ! (Bench flashing is fine) « Reply #1 on: March 13, 2015, 07:58:18 AM »

you can try via obd kwp mode with nefmoto software : http://www.nefariousmotorsports.com/wiki/index.php/NefMoto_ECU_Flashing_Software

this software have also bootmode but do not take this.. not working in nef software.

You can read/flash in car with nef without boot mode.

also don't try read with nef if you have a commercial tune in car.

last version of the software are here : http://nefariousmotorsports.com/forum/index.php?topic=2200.0

good luck !


	Logged

AndrewS

Newbie

Karma: +0/-1
Offline

Offline

Posts: 11

	Re: Can't flashing in the car ! (Bench flashing is fine) « Reply #2 on: March 15, 2015, 06:39:06 PM »

Thank you! Cheesy


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

April 26, 2024, 10:40:13 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search