Pages: [1]
Author Topic: Decrease CO for MOT?  (Read 4158 times)
mushtafa
Full Member
***

Karma: +3/-4
Offline Offline

Posts: 121


« on: March 17, 2015, 12:54:07 PM »

Not sure if this needs moving to the noob area or not?

Anyway, 1.8t, AUQ, few mods, good MAP.

CAT has been removed, so CO is too high to pass MOT emission test.

What can I change to lower it? The engine only needs to rev up to 3K with no load. (Only need to flash, emission test, flash back again).

Thinking out load now; Would decreasing the load request help? I'm not sure it will?

Cheers
Logged
prj
Hero Member
*****

Karma: +1072/-480
Offline Offline

Posts: 6035


« Reply #1 on: March 17, 2015, 01:02:28 PM »

The only way is to run it on E85 temporarily or some other exotic fuel.

Nothing you do with your tuning is going to let you pass MOT without a cat.

E85 should work though.
Logged

PM's will not be answered, so don't even try.
Log your car properly - WinOLS database - Tools/patches
armageddon
Sr. Member
****

Karma: +20/-3
Offline Offline

Posts: 348


« Reply #2 on: March 17, 2015, 01:54:31 PM »

You could put water into your exhaust, but then, lambda will be too hight  Grin
Logged
mushtafa
Full Member
***

Karma: +3/-4
Offline Offline

Posts: 121


« Reply #3 on: March 17, 2015, 02:26:47 PM »

Back to the drawing board then! Cheers
Logged
turboat
Hero Member
*****

Karma: +45/-3
Offline Offline

Posts: 619


« Reply #4 on: March 17, 2015, 04:22:04 PM »

Find a sympathetic tester or fit a cat.

If you're anywhere near Cardiff, pro-speed exhausts will fit flanges and build you a swappable cat/decat fairly cheaply.
Logged
mushtafa
Full Member
***

Karma: +3/-4
Offline Offline

Posts: 121


« Reply #5 on: March 18, 2015, 01:38:34 PM »

I'm an MOT tester, I'm sure I can come up with something! Just nice to do it all by the books  Grin
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)