Pages: [1]
Author Topic: General consensus on these logs  (Read 3880 times)
robsa6
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« on: April 25, 2015, 05:53:27 PM »

Ok so as the title states I'm looking for ideas and constructive criticism regarding these logs. I've been collecting info like a madman for months and slowly bringing my a6 to the point of these logs. The car is ko4's, EV14 550cc, new 710n's, catless dps w/full 2.5 magnaflow exhaust, lwfw, Stock MAF, 6MT... Thanks in advance and bring on the discussion.
« Last Edit: April 25, 2015, 06:14:30 PM by robsa6 » Logged
nyet
Administrator
Hero Member
*****

Karma: +608/-168
Offline Offline

Posts: 12270


WWW
« Reply #1 on: April 25, 2015, 06:00:15 PM »

Please post the log itself Smiley
Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #2 on: April 25, 2015, 06:01:28 PM »

No expert here, but looking at the log(s) with load, it looks like you need to log rl_w instead of rl so it does not flatline @ 191. Variables with _w are 16 bit vs. 8 bit non _w.
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
robsa6
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #3 on: April 25, 2015, 06:27:07 PM »

Thanks for the tip. I was wondering what the differences were! I'll re log tomorrow and change that. So the FATS time huh? HA I don't know what happened but I don't think im anywhere near that fast! I am wondering what I might have done wrong with the hp and tq graphs. Car feels good (ie faster than 300 hp but slower than 2.25 FATS)
Logged
nyet
Administrator
Hero Member
*****

Karma: +608/-168
Offline Offline

Posts: 12270


WWW
« Reply #4 on: April 25, 2015, 06:34:33 PM »

So the FATS time huh?

Its only showing your 2nd gear pull because your 3rd gear pull didn't start at a low enough rpm.


Log looks good though, good job.
Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
robsa6
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #5 on: April 25, 2015, 06:42:15 PM »

Thanks Nyet. This was all done traveling from long island to charlotte adjusting my fueling at rest areas... Brick my ECU? pffft. Honestly I was worried to death but it was killing me to watch my a/f meter run rich
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 16 queries. (Pretty URLs adds 0s, 0q)