You have way too much wgdc and are overboosting.
You are going to break something.
log PID variables.
I've got another config file with the PID and I actually brought the requested load back down from 219! duh to 191 and it smoothed out some. I think my PID is def an issue and I've not got a real good handle on it yet. I've read the Wiki a few times and am getting there but until now its not been super important. I fought a couple boost leaks over the last month and in between I adjusted the tune not realizing it still had another leak. Boneheaded thing to do I know but I finally built a leak tester and got her sealed up pretty well so (for now) I should be ready to tackle the boost PID. Ill log The PID tonight and post them later on. Thanks a lot NYET.
over boost !!!. Is all of the N75 hoses good ?? Is the N75 valve Good ...... If you have a ECS race N75 valve get rid of it !!
Lee
Yea I thought the N75 valve was bad and ohm tested it. I was at 31 ohms. I guess spec is 35? I even tested cold and hot since it seems ohms would possibly change based on temp... All vacuum has been addressed and I'm left thinking I've got my "tune" fubared... Thanks for the reply
