Hey Guys...
At first please forgive my poor english, i´m german and what i write is all i known from school
I hope to get a bit of help from you.
I´ve swapped a 1.8t AUM engine into my Polo 6N.
I drive the Engine stock with all components an with 06a906032FC ECU with SKN tune on it (i´m not sure if skn tune is really tuned, there´s a sticker in my ECU which shows data from skn, i wrote skn, they say it´s an ECO75 Tuning with 190HP and 275NM.... I read this bin and attached this post... Can anyone check this file please and tell me it´s really tuned or not).
Now i´ve all parts relatet to K04 without a new ECU.
Parts i have are
-K04-023 Turbocharger with exhaust manifold
-2,5" Downpipe
-Air Intake System Audi S3 (APX, 225HP)
-Intercooler, a bit bigger to stock S3 intercoolers, matched to mount on my Polo
-Air flow sensor APX225HP
-BMC Carbon Airbox
-Injectors from Audi S3 (APX, 225HP)
-All oil and water pipes for the K04
Sinter-Metall Clutch and Single-Mass-Flywheel are still mounted.
Can somebody tell me what mapping i can drive with this setup? Is it still possible without EGT?!
Must i build a Map by myself or can i drive another K04 stock map?
Can my File be modified to drive my K04 setup?!
What happens if i drive the K04 Setup with my SKN tune?
If modifying isn´t possible with my ECU perhaps i can drive the K04 Turbo only (without S3 Sir flow sensor and Injectors) without software changes?
Much thanks for reply,
Flo