Pages: [1]
Author Topic: hello need some help with audi b6 1.8T AVJ 110kw 8E0906018B  (Read 4767 times)
alutzu2000
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 3


« on: September 02, 2015, 12:17:35 PM »

hello , please help me with some advice , after i flashed my ecu (audi b6 1.8T AVJ 110kw 8E0906018B) with a moded file maybe was a noncompatible file or for different type of engine (i drove the car and was acting pretty good in agressive driving style wast good driving in normal condition ) with nefmoto flash i get 2 faults on engine controler via
Vag-com 311.2-N :18014 -rough road/engine torque signal from ABS : electrical malfunction p16606 - 35-00
              18020 Engine control module incorectly coded p1612 - 35-00
so i decided to flash again my ECU with my original file i have backed up before flashing and now i get the same errors and my ESP/ABS and brake lights are on in dashboard , i got no abs or esp working

i enter with vag-com 311.2-N in ABS/ESP controller and i get 3 more errors:
18256 please check dtc memory of engine controller p1848 35-00
01044 control module incorectly coded
00778 steering angle g85 66-10 not matched -intermitent

please help me fix this ESP/ABS problems with my vag-com 311.2-N because this one i got registered after i bought the cable from ebay or give me some solutions to fix it . Thank you
Logged
aef
Hero Member
*****

Karma: +70/-46
Offline Offline

Posts: 1601


« Reply #1 on: September 02, 2015, 11:25:33 PM »

Are you sure your second attempt to turn your ecu back to stock was successful?

Have you deleted your faults with vagcom?
Logged
alutzu2000
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 3


« Reply #2 on: September 03, 2015, 09:28:25 AM »

hello! yes was a successfull flash cuz was 2nd atempt 1st failed and card didnt want to start anymore then i reflashed and worked , i deleted faults but the ones im asking about canot be deleted .thank you
Logged
alutzu2000
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 3


« Reply #3 on: September 12, 2015, 05:58:10 AM »

hello all ! i manage to fix this issue , i had to recode the engine with vag-com beacose the engine soft coding and workshop codding went to 0000 so i used my old codes and for abs/esp i generated the soft code from the vag manual ussing the sticker in the trunk and after that i calibrated the esp with the login code 40168 , all works fine now no errors !
Logged
adam-
Hero Member
*****

Karma: +124/-33
Offline Offline

Posts: 2179


« Reply #4 on: September 14, 2015, 03:27:35 AM »

Thanks for completing this, it might help someone later! Smiley
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.027 seconds with 17 queries. (Pretty URLs adds 0.009s, 0q)