hopsis
Full Member
Karma: +13/-4
 Offline
Posts: 174
|
 |
« on: September 03, 2015, 01:07:57 AM »
|
|
|
Tunerpro allows you to copy or paste xdf parameters to/from clipboard. I have two Tunerpro instances open side by side, one has the more defined xdf file open and the other window has the one I'm working on. I was trying to copy defined maps from one xdf to the other and then just correct the map and axis addresses to match the other binary. This however doesn't work. When I [Ctrl +C] the parameter and try to paste it to the other window, nothing happens. I cannot even paste it to a notepad file, it's as though there is nothing on the clipboard. What am I overlooking here?
The binaries in question are basically identical, A6 4.2 ME7.1 and A6 4.2 ME7.1.1 so this would save me a lot of time and repetitive error-prone manual labor.
|
|
|
|
|
Logged
|
|
