To rise the RPM Limit to 7000:
NMAXDV - Drehzahlbegrenzung bei Fehlererkennung Geschwindigkeitssignal - 7000
NMAXF - Fehlererkennung nmax – Überschreitung - Diagnosis - 7300
And in my AGU 06A906018R 359591 @ 0732A 8bit 30x1
Original:
8A A3 A3 A4 AA AA C8 C8 C8 C8 C8 C8 8C A5 A6 A6 AA AA A7 A8 A8 A8 AA AA 8A A3 A3 A4 A8 AA
Changed to:
8A A3 A3 A4 AF AF C8 C8 C8 C8 C8 C8 8C AF AF AF AF AF AF AF AF AF AF AF 8A A3 A3 A4 AF AF
-So I changed from A5 and up (beside C8, which gives 8000)
-in the 30x1 map: Number 4,5, 13-23, 28 and 29.
And you need to raise the axis to 7000 in all the maps.
If I remember this correctly these are rpm's when it starts to cut individual cylinders.
And it's best not to set everything to the same value otherwise it's like driving into a wall.
This I will look more into, guessing it may be A5, A6, A7 and A8.
