Read issue-Factory ECU

Pages: [1]

« previous next »

Author

Topic: Read issue-Factory ECU (Read 3497 times)

nxm08240

Newbie

Karma: +0/-0
Offline

Offline

Posts: 5

	Read issue-Factory ECU « on: December 14, 2018, 01:51:11 PM »

I'm trying to read an ME7.5 ECU in a 1.8t. I can connect and read the ECU info just fine. When I go to pull the file off of it, I'm getting a memory validation error. I've verified that it's the stock tune by running the car on the dyno. Any input would be appreciated. Thanks!

Security access granted.
Validating flash memory starts at 0x00800000 and ends at 0x00900000.
Validation failed, ECU reports RequestUpload was rejected. RequestUpload may have been disabled by aftermarket engine software.
Memory layout validation failed.
Starting to read data block.
Requesting upload from ECU for address range 0x00800000 to 0x00803FFF.
Request upload from ECU failed, ECU reports RequestUpload was rejected. RequestUpload may have been disabled by aftermarket engine software.
Reading ECU flash memory failed. Trying to force ECU to recognize read operation is complete.
Finished forcing ECU to recognize that failed read operation is complete.


	Logged

nyet

Administrator
Hero Member

Karma: +607/-168
Offline

Offline

Posts: 12268

	Re: Read issue-Factory ECU « Reply #1 on: December 14, 2018, 01:55:23 PM »

Quote from: nxm08240 on December 14, 2018, 01:51:11 PM

I've verified that it's the stock tune by running the car on the dyno.

That means nothing, considering many aftermarket tunes have stock mode.

Boot mode. Bet you $100 it isn't stock.


	Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex

nxm08240

Newbie

Karma: +0/-0
Offline

Offline

Posts: 5

	Re: Read issue-Factory ECU « Reply #2 on: December 14, 2018, 02:04:07 PM »

Good to know. I'm coming over from the world of Subaru's so I'm spoiled with Cobb software... Haha. Am I able to flash a file over this one that is on here? Or does the ECU need to be bench flashed back once, then I can flash via OBD?


	Logged

nyet

Administrator
Hero Member

Karma: +607/-168
Offline

Offline

Posts: 12268

	Re: Read issue-Factory ECU « Reply #3 on: December 14, 2018, 02:56:08 PM »

Depends if the ecu has a riser for the flash.

If it doesn't, you can flash over it in bootmode with a stock file.

You'll have to open the ECU case to make sure.


	Logged

nxm08240

Newbie

Karma: +0/-0
Offline

Offline

Posts: 5

	Re: Read issue-Factory ECU « Reply #4 on: December 14, 2018, 04:32:25 PM »

Ok, looks straight forward. Just to clarify, if it has the riser, I should be able to flash a stock file over the current one through the nefmoto flasher?


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 23, 2024, 04:36:42 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search