Pages: [1]
Author Topic: write the 93cs56  (Read 3036 times)
disi77
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« on: September 03, 2019, 01:16:57 AM »

hi i have here a 93cs56. On the Chip is write: cs566. I classified as ST93cs56 an i can read. But i cant write. Any One know how i can write on the EEprom? I use Galep 4 and Carprog

its from a MK3 with 1ho919880Q Motometer
Logged
macxxx
Sr. Member
****

Karma: +29/-1
Offline Offline

Posts: 498


« Reply #1 on: September 03, 2019, 01:35:34 AM »

did you desolder it or are you trying to write it with a clip?

I have never had any problem using cheap EZP2000 or tl866 programmer
Logged
gremlin
Hero Member
*****

Karma: +179/-7
Offline Offline

Posts: 568


« Reply #2 on: September 03, 2019, 03:02:26 AM »

I classified as ST93cs56 an i can read. But i cant write. Any One know how i can write on the EEprom?

Check protection flags

Two flag bits are used to indicate the Protection
Register status:
– Protection Flag: this is used to enable/disable
protection of the write-protected area of the
M93Sx6 memory
– OTP bit: when set, this disables access to the
Protection Register, and thus prevents any
further modifications to the value in the
Protection Register.
Logged
disi77
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #3 on: September 03, 2019, 03:22:13 AM »

yes i desolder.

i found a option in my Galep but i think the eeprom is dead.... i cant write.... i can erase its all FF, the i open my backup, in Options from Galep i set Protection Register FF. Tehn i Writ but he dont write...
Verify Error
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)