Pages: [1]
Author Topic: Audi S4 B5, VisualME7Logger can only connect after Unisettings connection  (Read 4362 times)
RC200
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 10



I can only connect VisualME7Logger after having connected Unisettings one time (read params).
I cannot connect with only IGN on, I need to go through Uniseetings first.
Once connected, I can see the values updated in real time, so CFG and ECU file are ok

Of course, once connected with VisualME7Logger, if I try to crank it up, the engine dies as this is the normal behavior after Unisettings connection.
If I cycle the ignition, the engine starts but unable to connect anymore VisualME7Logger and you cannot go through Unisettings when engine is running ....
Chicken and egg ....

Error! Exit code:4
=>could not connect to ECU, exiting ...
exiting (cause=0x4)...

ECU 8D0 907 551D

Logged

----------------------------------------------------------
EURO S4 B5 2.7T 07/1999 Ph2 8D50J9
VIN: > 8DZYA00xxxx
ECU 8D0 907 551D
K04, 750cc, Walbro 485LPH fuel pump, 4bars FPR, MRC map
Running 100% E85 with UniSettings adjustment. Timing +7.5°. >350 rwhp.
13.5L/100kms on highway, 16-19 mix driving.
RC200
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 10


« Reply #1 on: February 25, 2020, 07:27:06 AM »

I succeeded in connecting with IGN ON using SLOW-0x00 aka double init (btw, I can hear the 2 consecutive bips coming from the cluster, as for connection with UniSettings).
BUT as soon as I crank the engine up, more precisely, as soon as I release the startup key, the values freeze (so connection dropped).
I tried various speeds without success.
Sometimes I got popups like the ones attached.
« Last Edit: February 25, 2020, 07:32:24 AM by RC200 » Logged

----------------------------------------------------------
EURO S4 B5 2.7T 07/1999 Ph2 8D50J9
VIN: > 8DZYA00xxxx
ECU 8D0 907 551D
K04, 750cc, Walbro 485LPH fuel pump, 4bars FPR, MRC map
Running 100% E85 with UniSettings adjustment. Timing +7.5°. >350 rwhp.
13.5L/100kms on highway, 16-19 mix driving.
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)