Trautec
Newbie
Karma: +0/-0
Offline
Posts: 7
|
|
« on: February 28, 2020, 01:48:30 AM »
|
|
|
Hello Guys, I swapped a 3B0 920 849 A full FIS Passat cluster into my Golf 4. I already got everything working except that the cluster is taking the signals from the plugs to control ABS and ESP lights instead of the CAN-Bus messages. Cluster, ECU and Brake have CAN connection - Only when I disconnect the CAN Bus from the cluster there are fault codes like "Missing CAN Bus message from XYZ" So for now, I have grounded pin 19 of the blue connector, so I dont have permanent flashing of ABS and brake warning in cluster Does anyone know which bit to change in this dump? I already know about 0x65 bit0 and bit1 controlling temerature and VSS via CAN/analog. I guess the setting for my Problem might be near this settings?
Thanks in advance
|
|
|
Logged
|
|