Hi all, long story short, I tried to disable the immo on an APR tuned ECU using Argdub's and turboat's eeprom tools. I've used them in the past for a factory ECU which was then flashed with another tune and never had any problems.

This is with a B6 1.8T ECU, PN: 8E0 909 518AK. APR Tune is a "Stage 1+" which uses 386cc injectors from a TT225, no other hardware required.

I was under the impression that the EEPROM is separate from the memory that the flash is stored on, so I'm not sure how that would have affected it. Unless the APR tune has a safeguard in it to prevent EEPROM changes.

For the record, the APR tune was on the car when I bought it (immobilizer active). I was chasing a lean issue with the TT225 injectors that it uses, so I switched to a stock injector tune (which verified that the injectors were clogged). I had the TT225 injectors cleaned and tested and decided to sell the tune and injectors. To make it easier for the buyer, I disabled the immobilizer as I had done in the past. However, when the buyer installed it in his car, it just cranks and cranks. I verified this issue in my own car after it was sent back to me. I also noticed that the dash lights stay on (ABS, ESP, etc) and the CEL is flashing with the key on. I checked for codes and there are none. The only codes I could find in an autoscan were "incorrect chassis (VIN) number", which I figured was due to the different VIN stored in the ECU eeprom. I was able to solve the codes after adapting the modules to the new VIN number, but it still wouldn't start.

The car starts and runs just fine when I put the other ECU in.

I apologize if this has been covered in the past, I tried searching and couldn't find anything similar. I would like to be able to use APR tune again, thankfully it didn't cost me anything, but at this point I just want to understand what went wrong.

Unfortunately, I don't have the before EEPROM. I accidentally overwrote it while using the eeprom tool. 

I can upload the after, though. Give me a moment, it's on my other computer.

I'm fairly certain it's the right EEPROM file. I even took the known good EEPROM from my spare ECU (same PN) and loaded it to the APR ECU.

Crap. Well, I guess I learned a lesson, the hard way.

This is the BIN I loaded to the ECU. I couldn't see how to attach a file in a PM. So here you go:

No worries, thankfully this tune came with the car, so it's not like I'm out any money. It just sucks knowing I basically destroyed the file.

 

Yep, I learned this the hard way, I guess. I assumed they would have the same EEPROM since the PN's matched.

Yup

You should be able to do it with any ftdi, just need to edit the galletto software with the ftdi serial. the information can be found in flashing section.