DQ250 (MQB) Wakeup

Pages: [1]

« previous next »

Author

Topic: DQ250 (MQB) Wakeup (Read 3702 times)

vt1111

Jr. Member

Karma: +0/-0
Offline

Offline

Posts: 27

	DQ250 (MQB) Wakeup « on: October 21, 2021, 01:17:24 AM »

Hi,

I'm trying to access to a DQ250 with VCDS. I connected the ECU over "Antrieb-CAN" with a MQB Gateway and the Gaeway with OBD. All Power Supply is on (KL15, 30). I send the KL15 Wakeup on "Komfort-CAN" with ID 0x3C0

I can access the Gateway and see that Klemme 15 over CAN is "on". But the DQ250 does not response. Any clues?

Thanks.


	Logged

cherry

Sr. Member

Karma: +26/-2
Offline

Offline

Posts: 260

	Re: DQ250 (MQB) Wakeup « Reply #1 on: October 21, 2021, 02:20:48 AM »

Check CAN termination (i think DSG does not have resistor inside) or make direct conntect with VCDS to DSG, then you also check termination.


	Logged

vt1111

Jr. Member

Karma: +0/-0
Offline

Offline

Posts: 27

	Re: DQ250 (MQB) Wakeup « Reply #2 on: October 21, 2021, 03:33:52 AM »

Hi,

thanks for your reply. As I connected TCU to GW there should be a termination inside. But anyway - I added a Termination Resistor but no change.


	Logged

jochen_145

Full Member

Karma: +9/-4
Offline

Offline

Posts: 177

	Re: DQ250 (MQB) Wakeup « Reply #3 on: October 22, 2021, 02:57:47 PM »

- Check AntriebsCAN at TCU at all: are there any IDs
- Check Klemmen_Status_01
- Check Network-Management

But also, TCU should be reatchable, if you connect VCDS directly to AntriebsCAN


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 28, 2024, 11:31:05 AM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search