Pages: [1]
Author Topic: DQ250 (MQB) Wakeup  (Read 3273 times)
vt1111
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 27


« on: October 21, 2021, 01:17:24 AM »

Hi,

I'm trying to access to a DQ250 with VCDS. I connected the ECU over "Antrieb-CAN" with a MQB Gateway and the Gaeway with OBD. All Power Supply is on (KL15, 30). I send the KL15 Wakeup on "Komfort-CAN" with ID 0x3C0

I can access the Gateway and see that Klemme 15 over CAN is "on". But the DQ250 does not response. Any clues?

Thanks.
Logged
cherry
Full Member
***

Karma: +23/-2
Offline Offline

Posts: 245


« Reply #1 on: October 21, 2021, 02:20:48 AM »

Check CAN termination (i think DSG does not have resistor inside) or make direct conntect with VCDS to DSG, then you also check termination.
Logged
vt1111
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 27


« Reply #2 on: October 21, 2021, 03:33:52 AM »

Hi,

thanks for your reply. As I connected TCU to GW there should be a termination inside. But anyway - I added a Termination Resistor but no change.
Logged
jochen_145
Full Member
***

Karma: +9/-4
Offline Offline

Posts: 177


« Reply #3 on: October 22, 2021, 02:57:47 PM »

- Check AntriebsCAN at TCU at all: are there any IDs
- Check Klemmen_Status_01
- Check  Network-Management


But also, TCU should be reatchable, if you connect VCDS directly to AntriebsCAN
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)