Trying to read the SKCPart  from an A6 '02 Cluster ( partNo: 4B0 920 901) ,    Component: KOMBI+WEGFAHRS. M73 D04 in order to pair a new ECU with old cluster.
Someone earlier did replace the ECU with a used ECU, but without pairing the two components.

Now I don't have the original PIN / SKC from the car / cluster, and need it to pair the units.

What is the best way to get a good readout of the cluster (have tried VAG _K+ CAN 2.5, but getting no good reading with any of the options) ?

And where will the SKC be located in the bin readout?
Only readout that I've been able to get is with settings for Magneti Marelli Shadow 1, but do not think this is a full readout.. (see attatchment)

you won't read a MM Jeager cluster with bag eprom programmer , maybe Vagtacho will do it ( but it's a a piece of crap )

what do you want to do? why do you want to pair it? the best way is to throw the MM/Jeager cluster to trash , it will fail sooner or later , buy a VDO will Full FIS and then adapt it

it's a Jeager/MM for sure , and as I know there were no half Fis VDO cluster In a Facelift A6 C5

Read ECU pin , maybe modify VIN to match yours , put new transponders in keys , read new cluster PIN and adapt - of course you can adapt cluster manually modifying it's dump ( I can help you if you want )

No diesel 2.5 is different ECU , use vag k+can commander 1.4 , It works with kkl cable , IT should immo off

my friend, you don't give any files but ask questions, it's hard to say where and what mistakes are you making that the car won't start
share eeprom of old and new ecu
i think you have vagcancommander so read dash as direct