Pages: 1 [2]
Author Topic: 17964 - P1556 Charge pressure control; negative deviation. HELP please  (Read 9133 times)
nyet
Administrator
Hero Member
*****

Karma: +607/-168
Offline Offline

Posts: 12268


WWW
« Reply #15 on: February 08, 2023, 03:57:06 PM »

Actual boost is at least EDLDRP less than target

Max DC is unable to correct the error


that sounds like positive deviation

http://nefariousmotorsports.com/forum/index.php/topic,871.0title,.html

neg deviation limit should be lde very negative and ldi reaching minimum due to overboost.

I've seen this swapped, depending on scan tool and even ECU

http://nefariousmotorsports.com/forum/index.php?topic=7524.msg69342#msg69342
http://nefariousmotorsports.com/forum/index.php?topic=7524.msg69436#msg69436
« Last Edit: February 08, 2023, 03:59:32 PM by nyet » Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
phila_dot
Hero Member
*****

Karma: +173/-11
Offline Offline

Posts: 1709


« Reply #16 on: February 08, 2023, 05:15:34 PM »

I don’t know about the semantics of the description, but in 551M:

LDRA throws P1556 (underboost)
LDO throws P1555 (overboost)

LDRA will also throw P1556 if the ratio ps_w/pvdkds_w exceeds the threshold from KFVPDKLD.
Logged
prj
Hero Member
*****

Karma: +1072/-480
Offline Offline

Posts: 6035


« Reply #17 on: February 08, 2023, 07:24:00 PM »

Positive deviation is always underboost and negative deviation is overboost.
Too lazy to check but scan tools get them wrong sometimes.
Logged

PM's will not be answered, so don't even try.
Log your car properly - WinOLS database - Tools/patches
maxXAM
Jr. Member
**

Karma: +0/-6
Offline Offline

Posts: 33


« Reply #18 on: February 09, 2023, 11:30:00 PM »

i see you all guys are still confused about my situation here
here is the story my car is 2002 s4 2.7t tiptronic swapped to manual transmission a year ago, the original ecu  was aa-box flashed to m-box, i did some modes on that car like rear os delete egt delete and rebuild  both turbos.
since then car runs just fine no issues at all no chek lights , but about a week  i start smelling gas i poped the hood i found all injectrs leaking gas evry where i tought its maybe the injectors seals needs to be replaced and i did replaced all injectors seals and when i did that i think i installed back the check valve for the evap valve  backwards because since then the 5psi issue start to happen with no fault codes because i never get my s4 under load or hard driving so maybe  that's why she is not throwing fault codes
i took my friend advice pushed my s4 hard on highway till the check light turned on returned back to my place plugged in vagcome and found the P1556  Charge pressure control; negative deviation
i fx it now every think good but my injectors still leaking
replaced the fuel rail same thing all injectors leaking so i thoaght its mybe the injectors are bad.
 i got 06a9060311.8t injectors in my garage so i told to my self lets try them so i puted  them on ,car start fine no leaking gas any more so i orderd ev14 550c injectors and that's it end oof the story


« Last Edit: February 11, 2023, 10:50:59 AM by maxXAM » Logged
_nameless
Hero Member
*****

Karma: +342/-466
Offline Offline

Posts: 2800



« Reply #19 on: February 10, 2023, 08:41:17 PM »

i see you all guys are still confused about my situation here
here is the story my car is 2002 s4 2.7t tiptronic swapped to manual transmission a year ago, the original ecu  was aa-box flashed to m-box, i did some modes on that car like rear os delete egt delete and rebuild  both turbos.
since then car runs just fine no issues at all no chek lights , but about a week  i start smelling gas i poped the hood i found all injectrs leaking gas evry where i tought its maybe the injectors seals needs to be replaced and i did replaced all injectors seals and when i did that i think i installed back the check valve for the evap valve  backwards because since then the 5psi issue start to happen with no fault codes because i never get my s4 under load or hard driving so maybe  that's why she is not throwing fault codes
i took my friend advice pushed my s4 hard on highway till the check light turned on returned back to my place plugged in vagcome and found the P1556  Charge pressure control; negative deviation
i fx it now every think good but my injectors still leaking
replaced the fuel rail same think all injectors leaking so i thoaght its mybe the injectors are bad.
 i got 06a9060311.8t injectors in my garage so i told to my self lets try them so i puted  them on ,car start fine no leaking gas any more so i orderd ev14 550c injectors and that's it end oof the story



Have you checked wastegate cracking pressure with a gauge and hand regulator before installing rebuilt turbos? Could have boost creep due to wastegates not being set correctly Also, make sure the n75 is plumbed proper and hoses are not burnt / melted going to the wastegate actuator. Posting some actual logs would really help your situation. 
Logged

Giving your mom a tuneup
maxXAM
Jr. Member
**

Karma: +0/-6
Offline Offline

Posts: 33


« Reply #20 on: February 11, 2023, 10:45:30 AM »

no i didn't check the wastegate with gauge but i did test them with compressed air they are working properly and about  the n75 valve i clean it with wd40, installed back checked all pressur hoses from the n75 to wastegate all good i will do some logs but what's about the leaky injectors are thy failing like that leaking like the are cracked   
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 17 queries. (Pretty URLs adds 0s, 0q)