I have a been working with this ecu for quite a while n/a and im going to be adding a turbo in the near future and wanted to know if there are any maps i should be considering beside kfzw and its counter parts, injector scaling, changing the load scaling, also adding fuel with lamfaw and the maf correction map. i will be using the stock maf for a blow thru set up on low boost with in its limits. im also considering 630cc injectors to leave room for higher boost and or e85. where should i start? fueling then timing and obviously part throttle then full throttle. any tips or suggestions would be greatly appreciated.

Thank you, I see what you mean about the sensor. I plan on switching to an HPX sensor and higher boost down the road. thats a good idea for the injectors, thanks again. Maybe i could add a piece of foam after the intercooler before the maf to catch any oil that gets thru the system.

I bit my tongue on that one when I read it lol

It's not the foam that is your problem it is where you put it.