bad checksum, car won`t start. need help

Pages: [1]

« previous next »

Author

Topic: bad checksum, car won`t start. need help (Read 6154 times)

ventovr6qc

Newbie

Karma: +2/-0
Offline

Offline

Posts: 14

	bad checksum, car won`t start. need help « on: April 19, 2011, 07:33:49 PM »

i just resoldered a new chip after a bad checksum flash and the car still won`t start.
it can`t even connect with vag-com or nefmoto on the kwp2000 protocol
is it because i haven`t removed the checksum error? if so, how do i remove it

thanks


	Logged

judeisnotobscure

Sr. Member

Karma: +38/-10
Offline

Offline

Posts: 379

	Re: bad checksum, car won`t start. need help « Reply #1 on: April 19, 2011, 07:50:52 PM »

read this thread
hope it helps
http://www.nefariousmotorsports.com/forum/index.php/topic,415.0title,.html


	Logged

I have a b5 s4
but i just want to dance.

ventovr6qc

Newbie

Karma: +2/-0
Offline

Offline

Posts: 14

	Re: bad checksum, car won`t start. need help « Reply #2 on: April 19, 2011, 07:54:41 PM »

read it already
still a no go


	Logged

setzi62

Full Member

Karma: +142/-0
Offline

Offline

Posts: 249

	Re: bad checksum, car won`t start. need help « Reply #3 on: April 20, 2011, 02:11:58 AM »

Did you program the new flash chip with the original image? If VAG-COM or NefMoto can't
connect after soldering in the new flash chip with orig image, you might have a soldering
problem. Check that all connections are fine and that there are no short circuits.
Connection via K-line should work independent wether there is a checksum error or not.

The checksum error is stored in the EEPROM and is not cleared when replacing the flash chip.
You can reprogram the EEPROM or do a complete flash cycle with NefMoto to get rid of this.


« Last Edit: April 20, 2011, 12:09:49 PM by Tony@NefMoto »	Logged

julex

Hero Member

Karma: +79/-4
Offline

Offline

Posts: 923

	Re: bad checksum, car won`t start. need help « Reply #4 on: April 20, 2011, 08:27:38 AM »

Quote from: ventovr6qc on April 19, 2011, 07:33:49 PM

Get galletto 1260 and try boot mode if your chip supports it that is. I think you went a bit overboard with the whole soldering activities. Normally, even if you screw the ECU while flashing, you can re-flash once you dicsonnect the ECU from battery for at least 1 minute.


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 27, 2024, 04:45:12 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search