tried using minimon, galletto, nefmoto and MPPS software, cant get the ECU to go into Bootmode. They start the car but cant red/flash them i have about 5 of them that are like this. Anyone have a similar issue or know what i can try to make them go into boot mode?

Sanity check:
you do short the pins to go into boot mode right?

I was successful going into boot mode with 3 separate a6/allroad ECUs, 1 original allroad, 2 A6. The trick with them is that while getting galletto to enter ECU into boot mode is usually successful, on my setup anyway, finishing read or write is a totally different affair.

The like to fail a lot.

If you ever fail after the initialization mode, do not attempt another boot mode imemdiately. Disconnect the ECU and wait AT LEST 1 minute.

I just soldered two wires to the pads there and routed outside of the box, this way I can short exposed conductors at will without screwing around PCB itself each time. Two short leads would work too.

Do you see activity on your galletto cable LED when you try entering boot mode?

its ME7.1

yea but works on some ECU's and wont work on other Newer ecu's vagcom on bench.. Any idea why?