Pages: [1]
Author Topic: S3 8l BAM after recovery in bootmode - faultcode AMP faulty  (Read 4348 times)
NicoH
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 3



Hello,
at first sorry for my bad english...

I tried to flash a new software over OBD using Galletto. It stopped during flashing.
After this i get it out and recovered it by using bootmode.
It works now, the car starts and running. But I get some faultcodes:

control unit - AMP faulty
Speedsignal broken sporadically
Airbag-Crash-Signal broken sporadically

8N0906018BH

Maybe some of you have ideas !

Many thanks in advance !
Logged
sonique
Sr. Member
****

Karma: +24/-12
Offline Offline

Posts: 283


« Reply #1 on: May 09, 2017, 10:47:58 AM »

i think try flashing another sw version this ecu not original
Logged
yxx499
Full Member
***

Karma: +4/-10
Offline Offline

Posts: 106


« Reply #2 on: May 09, 2017, 11:35:40 AM »

Post here an ECU ID or a photo with your ECU to give you an Original file.
Logged
NicoH
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 3


« Reply #3 on: May 10, 2017, 01:27:48 AM »

I've two maps.. the original i read before and the tuned map... i already tried both of them with the same failures.

i think there must be an other failure, one time i could flash over OBD and another try bricks.. than i have to
disassable and recover in bootmode...
Logged
ivan
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 63


« Reply #4 on: May 10, 2017, 03:30:09 AM »

Look for your original file, the original for your ecu hw number, and try to flashed again then clear fault codes with vcds or other tool.

It looks like it is not the correct software for your ecu.
Logged
ivan
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 63


« Reply #5 on: May 10, 2017, 03:31:51 AM »

Here you have your original file:
Logged
adam-
Hero Member
*****

Karma: +122/-33
Offline Offline

Posts: 2178


« Reply #6 on: May 10, 2017, 07:25:52 AM »

Where did you get this tuned file from?
Logged
NicoH
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 3


« Reply #7 on: May 10, 2017, 10:31:32 AM »

Thanks for the original File...

The tuned one ist from a good tuner, the file works 4 month without problems so this is not a problem.

I wrote an speacialist and he told me that the hardware seems to be broken.

i will buy a used one and try this..

Many thanks i`ll sent feedback
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 17 queries. (Pretty URLs adds 0s, 0q)