I am helping a friend with his RS4, and doing the linearization runs we hit a problem

At 40% wgdc we change to 4bar sensor and 5120 hack

I am helping a friend with his RS4, and doing the linearization runs we hit a problem

At 40% wgdc we change to 4bar sensor and 5120 hack

The throttle is being close and I can not figure out whats causing it

He is runing 1.1bar wastegate actuatores

I thought it was of being requesting too much too early causing an underboost, but after change that it´s still the same

I suspect KFVPLGU is the problem, on 5120 hack I only divided the axis, does the table need to be divided also?



attached 2 logs, one without throttle closing and one with

the good one is only till 4000rpm cause the battary died

don't mind the wrong scaling, he used the wrong .cfg

any ideas for what is causing throttle cut?

lol 113 @ 3psi its a mess