Used un-checksummed file and got no start.

Pages: [1]

« previous next »

Author

Topic: Used un-checksummed file and got no start. (Read 3723 times)

seany260

Full Member

Karma: +0/-1
Offline

Offline

Posts: 119

	Used un-checksummed file and got no start. « on: October 12, 2017, 09:09:40 AM »

First of all I'm not new here, I know how to do boot mode and use most tools available on the forum.
I've flashed a file by mistake to my car driven it to work and then got a no start, done this before but usually outside the house and I just remove the ecu and boot mode flash.
Is there any other way around this, as Nefmoto flasher does not connect because of the non-corrected file.


	Logged

b5_nick

Newbie

Karma: +0/-0
Offline

Offline

Posts: 8

it's broken

	Re: Used un-checksummed file and got no start. « Reply #1 on: October 12, 2017, 09:30:16 AM »

I had this happen to me a couple of times by mistake. What I found to work for me was to unplug the battery, then unplug the ECU and let it sit for a few minutes (10-15 minutes worked for me). Then you should be able to plug the ECU and battery back in and connect via nefmoto. DO NOT try to start the car again until you flash your old file back.


	Logged

seany260

Full Member

Karma: +0/-1
Offline

Offline

Posts: 119

	Re: Used un-checksummed file and got no start. « Reply #2 on: October 12, 2017, 09:42:19 AM »

Ok I'll give that a try, It would save me a bit of to and fro in work.
I'm guessing that is on a B5 A4, mines a B6.


	Logged

b5_nick

Newbie

Karma: +0/-0
Offline

Offline

Posts: 8

it's broken

	Re: Used un-checksummed file and got no start. « Reply #3 on: October 12, 2017, 09:52:27 AM »

Yes, my experience is with a b5 s4, but I would assume it would work the same on the b6. Let me know if it does!


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 27, 2024, 02:37:45 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search