Hello Prj,

Yes I'm High. Unfortunately, I did a mistake, you didn't write this:


So I'm sorry.

However, like I mentioned. Before to do any forum request, I tried to find a solution alone. So I paid some tokens on a website and Like I was so stupid, I didn't be able to use it.
Then, I requested support and like the idea of Prj was great. I used my token to have a file with immo off instead off immo transfer (and less stupid in order to have positive answer).
I flashed it and it doesn't work.

I tried to explain this but it seems than it was not clear.
So know, after to falling down from High. I went to the website and I tested my file before pay the service.
And unfortunately, the answer is: ERROR: The file is not supported!
I used the Internal flash (4096Ko).

I'm really but really really happy to have this option on the website in order to check before to pay.

So thanks a lot, but it seems that I'm really unlucky OR COMPLETELY STUPID and what else.

Thanks for your time.

I have a KT200 with latest Sw.

Good luck using shit tools then. Send the car to someone competent and who uses proper tools in order to get the job done.

Hi,

I would like to share my simos18 adventure which was long and finish with a success.
After to see that all address from MCU was not correctly read with the tools, I went to VW after sale services.
It was possible to proceed ECU exchange with extra rights even if was not a new one.
Anyway, we don't know if the policies changed or it was not possible to adapt immo with a wrong SW, but all procedures finished with error.

After that, I had the chance to find a correct tools in order to be able to have a real full read.
So, I confirm that it was my main issue so I was not able to follow the advices.
Only for testing, I create an immo off solution from www.weboctopus.nl and I confirm the solution was not working => SAFE on Dash but DTC (ECU blocked) was not set.
I think it's a partial immo off or something likes that.

In conclusion, the correct way for me was:
- Read Donor ECU
- Create a real immo off solution from VehiCAL.net
- Flash the correct SW with .frf file
- Now, immo is on again, so we have to pay a new service on VehiCAL.net. they don't use MCUID but SW numbers also. I used another way.
- Read damaged ECU and donor ECU again
- Transfer immo information from damaged to the donor with www.weboctopus.nl
- Flash again the Donor with immo information changed
- Put in the car.
- Realize a ride 

Thanks for the tips.

Good to know.

Thanks again