Pages: 1 [2]
Author Topic: GOLF 7 Simos 18.1 Immo transfert  (Read 1529 times)
Frenchfries
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #15 on: October 09, 2024, 08:55:08 AM »

Hello Prj,

Yes I'm High. Unfortunately, I did a mistake, you didn't write this:

Transfer will not work by HSE. But disabling immo possible via same vendor you mentioned. There quite few suppliers online for that actually.

So I'm sorry.

However, like I mentioned. Before to do any forum request, I tried to find a solution alone. So I paid some tokens on a website and Like I was so stupid, I didn't be able to use it.
Then, I requested support and like the idea of Prj was great. I used my token to have a file with immo off instead off immo transfer (and less stupid in order to have positive answer).
I flashed it and it doesn't work.

I tried to explain this but it seems than it was not clear.
So know, after to falling down from High. I went to the website and I tested my file before pay the service.
And unfortunately, the answer is: ERROR: The file is not supported!
I used the Internal flash (4096Ko).

I'm really but really really happy to have this option on the website in order to check before to pay.

So thanks a lot, but it seems that I'm really unlucky OR COMPLETELY STUPID and what else.

Thanks for your time.
Logged
IamwhoIam
Hero Member
*****

Karma: +52/-115
Offline Offline

Posts: 1070


« Reply #16 on: October 09, 2024, 09:43:58 AM »

What tool are you using in order to read and flash those ECUs?
Logged

I have no logs because I have a boost gauge (makes things easier)
Frenchfries
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #17 on: October 09, 2024, 09:53:30 AM »

What tool are you using in order to read and flash those ECUs?

I have a KT200 with latest Sw.
Logged
Frenchfries
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #18 on: October 11, 2024, 08:08:12 AM »

Hi,

So I found why it doesn't work. Some parts of my dump is encrypted like I thought.
It seems that KT200 II tools is not enough to have a full decrypted Iflash.
For tuning seems ok because I checked with s19 file and tables are clear.

Thanks.
Logged
IamwhoIam
Hero Member
*****

Karma: +52/-115
Offline Offline

Posts: 1070


« Reply #19 on: October 11, 2024, 08:47:39 AM »

Good luck using shit tools then. Send the car to someone competent and who uses proper tools in order to get the job done.
Logged

I have no logs because I have a boost gauge (makes things easier)
Frenchfries
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #20 on: October 11, 2024, 09:05:22 AM »

Thanks for your time,

yes you're right.
No problem, I will do by another way.

Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 16 queries. (Pretty URLs adds 0s, 0q)