Pages: [1]
Author Topic: Need proper cable to start data logging.  (Read 4853 times)
cederrowe
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 17


« on: April 15, 2014, 09:53:22 AM »

Any good links to proper cable.
Ordered two cables and both companies never sent off ebay (got refund), and alphabid "recommended" changed there chip from the recomended 232r if i remember correctly but does work for vcds. Any links to working cable to order? So I have been stuck data logging with vcds which is to slow sample rate. Thanks for any info.
Logged
SB_GLI
Hero Member
*****

Karma: +115/-10
Offline Offline

Posts: 1022


« Reply #1 on: April 15, 2014, 12:33:10 PM »

I'd think you could use whatever cable you are using with Vag-com right now.  Perhaps you need to install virtual com port drivers to emulate a com port.  Just make sure you specify the proper com port to use with ME7Logger.
Logged
cederrowe
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 17


« Reply #2 on: April 16, 2014, 08:45:31 AM »

I downloaded the drivers ftdi?
Then installed them
went to drivers hardware and selected the correct port.
Nefmoto wont connect, and I get a error with ME7 logger
Which com option should I be selecting?
Also I have to drop my stock ecu file in the ME7 logger? What if its allready on Nefmoto tune?
Logged
ddillenger
Hero Member
*****

Karma: +637/-21
Offline Offline

Posts: 5640


« Reply #3 on: April 16, 2014, 09:36:56 AM »

You need to uncheck "boot in intelligent mode" in the VCDS options.
Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.024 seconds with 18 queries. (Pretty URLs adds 0s, 0q)