Pages: 1 [2]
Author Topic: AWT swap  (Read 15678 times)
masterj
Hero Member
*****

Karma: +61/-5
Offline Offline

Posts: 1049



WWW
« Reply #15 on: January 26, 2015, 02:42:03 PM »

Ok so both AWT, AWM are interchangeable. What are alternatives to these?

I've scanned through a lot of codes on etka and these also sparked interest:
AWL BGC CFMA AMB ARK AVJ BFB BKB BEX

Anyone knows if they're direct swap (VVT is not important)?

BTW: AEB, AJL, ANB, APU has old style coil sockets (square). On AWT they are newer.

BTW2: Nice find: http://domas.hard.lt/vag-codes-etka/
« Last Edit: January 26, 2015, 02:45:32 PM by masterj » Logged

TijnCU
Hero Member
*****

Karma: +60/-4
Offline Offline

Posts: 690


flying brick


« Reply #16 on: January 26, 2015, 03:54:17 PM »

BEX is from S3 sorry this was wrong info. Its longitudinal, all transverse blocks you need to change out the manifolds. I personally would just get the cheapest block with the lowest mileage, and then swap over any parts you need. I have an AEB block with APU harness, running on 225 APX file with ME7.5NB and all I needed to swap on the block itself was the cam timing wheel (€5,- from VW)  and the throttlebody (scrapyard).  
« Last Edit: January 28, 2015, 02:18:41 AM by TijnCU » Logged

_mumin_
Jr. Member
**

Karma: +2/-0
Offline Offline

Posts: 46


« Reply #17 on: January 28, 2015, 10:29:24 AM »

BFB, BEX, AVJ, AMB all are  longitudinal blocks so should be ok .
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 16 queries. (Pretty URLs adds 0s, 0q)